Mitel Inter-Tel Axxess, Руководство администратора

Страница: 35 / 384

Page 19
Administrator Procedures
Inter-Tel
®
Axxess
®
Administrator Guide — Issue 11.0, May 2008
Station Programming
The Station Database Programming process is summarized in the flowchart shown on page 23 .
See page 67 for a Program Planning Sheet.
NOTE:
If necessary, at any time during the following procedure you can press the asterisk
( ) or Speaker button to cancel programming and discard any unsaved changes.
To program stations:
1. While on-hook, enter the Program Database feature code (9932 or 9931).
2.
If a password is required, the display shows ENTER PASSWORD. Use the dialpad to
enter your 1-8 digit password and press . (If you enter an incorrect password or do
not press , the display shows INVALID PASSWORD.)
If a password is not required, skip this step.
3.
The display shows ENTER DATABASE OPTION. (Display endpoints also show the
options: STATION, SYSTEM, and TRUNK.)
Press or the STATION menu button.
4.
The display shows ENTER STATION EXTENSION. Enter the extension number of the
station to be programmed using one of the following methods. (If you enter an invalid
extension number, you hear reorder tones and must try again.)
Enter a complete number: Enter the extension number using your dialpad. When the
circuit information is displayed, press again to continue.
Enter a partial number: Enter a partial extension number, then press , the high end
of the volume button, or the ACCEPT menu button. The display shows the extension
number, username and circuit number of the station that most closely matches the par-
tial extension number. Press
or ACCEPT to program the displayed station, or scroll
to another station as described below.
Scroll through the numbers: To scroll through the extension number list, press the
high end of the volume button or NEXT to scroll forward, or press the low end of the
volume button or PREVIOUS to scroll backward. When the desired extension number
is displayed, press or ACCEPT to continue.
#
#
1
#
#
#
#