© Copyright
MINOS DIS TICARET LIMITED SIRKETI., 2020. All rights reserved. Reprinting, even of sections, only possible with the approval of
MINOS DIS TICARET LIMITED SIRKETI.
Document No: T-MDR.2020_I.O.M./ Date: 09.01.2020
Before leaving the machine unused for a long time, it's necessary
to carry out following tasks to preserve the appearance and functionality of
the machine, and to make easier the restart at later use:
● Park the machine on a flat surface, in a dry place protected from exposition
to the elements
(see section 4.4)
;
● Thoroughly clean the machine, and remove from the rotors all residues due
to soil working, in order to avoid damage from grass and stagnant water;
● Inspect carefully the machine, checking for worn and/or damaged parts.
Perform immediately all repairs and/or replacements needed, in order to make
the machine ready for restarting;
● In case of abrasion of painted surfaces, provide restoring the surface
protection through touch-up paint, in order to prevent rust;
● Make sure the safety decals are in their original positions, intact and legible.
When required, replace the decals immediately;
● Lubricate properly all grease points, and restore oil levels as indicated in the
section 5.4
.
● Use protective oil to coat the exposed mechanical components and to
protect them against rust.
● PTO shaft is equipped with a friction limiter clutch, it is suggested to take
note of the height of the compressed springs and loosen the bolts that
compress the springs, to prevent the "sticking" effect of the discs due to
moisture, that may cause clutch failure at restart of the activities
(see also
section 5.5)
.
6- STORAGE
55