© 2013 MIMAKI ENGINEERING CO.,LTD.
7.1.1
P.2
7.1.1 Concerning Errors and Malfunctions
R.1.0
Checking Procedure
This section describes troubleshooting procedures for the problems for which error messages are displayed.
1.Identifying the error category
The causes of errors can be classified into the following categories:
Handling error on the host computer side
Trouble on the host computer side
Trouble with the Interface Cable
Printer handling error
Printer mechanical trouble
Printer hardware trouble
Printer firmware trouble
2.Initial action
Refer to the error message, and judge whether the trouble lies on the host computer side or on the printer side.
Has any of the interface conditions (printer model setting, command, communication conditions, etc.) been
changed?
Does the trouble occur under specific conditions?
Does the same trouble occur repeatedly?
3.Failure on the printer side
Take the following steps to repair the printer.
Uploading and checking of parameters
Reinstalling of firmware
Checking of FFC and cable connections
Replace the defective part (sensor, etc.) or make the necessary adjustment.
Replace the PCBs.
4.Repair at the factory
If the error recurs even after the corrective measures specified here are taken, return the printer to the factory of
MIMAKI for repair.
MAINTENANCE MANUAL > Troubleshooting > Details on Errors and Malfunctions > Concerning Errors and Malfunc-
Model SWJ-320S Issued 2012.07.19 Revised
F/W ver
SWJ-
Issued
1.0