© 2013 MIMAKI ENGINEERING CO.,LTD.
4.2.7
P.3
4.2.7 [HEAD ADJUST] POSITION ADJUST
R.1.0
3. Turn the adjustment screw of the Head adjust tool. The head is
moved back and forth.
4. Print the pattern again and examine it.
5. When finished, tighten the two screws to secure the head.
6. Remove the two screws fixing the Head adjust tool, and remove
the tool.
Screw
Head
One turn of the adjustment screw moves the head
approximately 500
μ
m.
In which direction to turn the screw:
Clockwise:moves the head backward.
Counterclockwise:moves the head forward.
Repeat the adjustment and check with the pattern
until the dots align in the tolerable range (Tolerable
range: 0 ± 10
μ
m).
After the head position adjustment, perform the
head slant adjustment and position adjustment
again and repeat them alternately until the both
needs no more adjustment.
The head unit sometimes does not completely return
to the front side. Make sure to push the unit against
the end of the front side and then secure it.
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] POSITION ADJUST
Model
SWJ-320S
Issued 2013.03.08 Revised
F/W ver
2.20
Remark
1.0