Mechanical installation
Each machine is delivered with the drum locked
in place by four security bolts fitted between the
frame and the drum. In order to remove these
and install the machine, proceed as follows:
•
Unpack the machine.
•
Slacken off the screws in the lower edge of
the front cover plate and remove the plate by
pulling downward and outward to unhook it
from the chassis.
•
Unscrew the retaining screws on the rear
plate and remove the plate. Remove the
drainage connection by unscrewing the two
screws. Lift the drainage connection upwards
until comes loose from the rear plate.
•
Mark and drill two holes (diameter =5/16")
about 4" deep in the positions shown.
•
Remove the machine from the transport pallet.
Fit the adjustable feet provided.
•
Place the machine above the bolt holes you
just drilled. Always lift the machine by the
chassis, never by the door or door handle.
•
Remove the four security bolts holding the
drum to the chassis.
NOTE!
These security bolts must be removed
before operating the machine or it may be
damaged.
•
Check that the machine is level and steady.
Adjust the level by using the four adjustable
feet (check first that they are screwed in as far
as possible). Lock the feet using the lock nuts
when the machine is satisfactorily positioned.
NOTE!
It is of utmost importance that the
machine be level, from side- to- side as
well as front- to- rear. If the machine is not
properly leveled, it may result in a false
out-of-balance cutout.
•
Insert the expansion bolts supplied in the
holes drilled in the floor.
Fit the washers and nuts, and tighten well.
After the machine has been in use for a while
check and retighten the nuts if necessary.
0674
0244
0672
0671
6
EX 7
EX 10
720 mm
65mm
230mm
260mm
230mm
2 9/16 in
9 1/16 in
10 1/4 in
9 1/16 in
28 11/32 in
EX-25:
820mm
32 9/32 in
EX-15:
660mm
26 in
Fig.
4
Installation
3
4
5
6
Fig.
5
Fig.
3
Fig.
6