Installer Manual
Microvideo srl
www.microvideo.eu
58
CHAPTER 5 – Plant Management by GSM/GPRS Module
INSERTING AND
DISCONNECTING
See. "Armaming/Disarming"
SY825/SY826
RFID
READER
Form used for recognition of RFID keys, each module can be associated with four Macros that can be activated to recognize a Valid Key.
MACRO
Set of actions that are run sequentially
ALARM MEMORY
Whenever an alarm occurs, a code or Key Login fails, the Alarm /Diagnostics LED of all Keyboards Flashes.
USER MENU'
Set of operations that a user can perform through the SY820 keyboard once entered a valid user code. A user can activate a macro,
change some of the programming data, request Remote assistance, refer to the Event Log or display some information of the State Plant
PATROL
Procedure that can be triggered either by a key than from a code (previously programmed) which provides the Disarmingof one or more
areas and their immediate Reinserting with a previously programmed time of output
TAMPER
Event that is generated when a module from the Control unit stops responding to the System. This can happen for a Sabotage, a tampering
or a failure of the module
SY820 KEYBOARD
Main module for user interface with the system. Using the Keyboard you can Program the whole system or start macro view state data of
the Plant, every keyboard also has an integrated RFID key reader for the recognition of keys previously configured.
REMOTE ASSISTANCE
Procedure started by User by SY820 keyboardor SY860 combiner that triggers Internet connection of GSM SY860
Module, SY860 communicates its IP address (by SMS or by SY820 keyboard display) that must be communicated to
the installer to allow Remote assistance
INPUT TIME(OR INPUT
DELAY)
Time between the unbalance of a sensor and the generation of Zone Alarm event. This time is typically used as time input to reach the
module that allows you to Disconnect the system.
OUTPUT TIME
(OR NOTICE)
Time between the of a Armaming procedure of one or more areas and effective insertion of the same areas
TIMER
Time bands Weekly programmable. For each day of the week it is possible to define a time slot (with start time and end time).
Timers can be used to define the time bands, Enable / Disable Codes and Keys or to start Macros automatically.
OUTPUT
Electrical output clamp of the Unit SY800/810 for connecting Sirens, Acoustic detectors or actuators that can be activated or deactivated on
events generated by the system or by macro triggered by User
ZONE
Electrical input clamp of the unit SY800/810 for connecting Sensors for alarms detection
EXCLUDED ZONE
Zone whose alarms are ignored by the system, because excluded voluntarily by User or in automatic mode by the system
