Microvideo Synergy SY800, Инструкция по эксплуатации

Страница: 43 / 69

Installer Manual Microvideo srl www.microvideo.eu
43 CHAPTER 4– Programming Control Panel
Inser.Man. RA (0...65000) Value (ohm) of RA Resistence (Alarm Resistence)
Inser.Man. RT (0...65000) Value (ohm) of RT Resistence (Tamper Resistence)
RADIO ZONES
Parameter Options Description
Enable
Yes Zone Enabled
No Zone Disabled
Description 20 characters Description of the zone. Description apprears during configuation: by Keyboard, by
SynergyPro SW, in logs, in SMS messages concerning the zone.
Exclusion Type Auto-excludable It represents a zone that can be temporarily Excluded (in a plant inserting) if it appears
alarmed during Area Arming
Not Excludible You can never Exclude that zone, so you always must "estimate" it during Plant Arming
DelayTime (0..65000) Delay time (seconds) in the area if ZONE type is Delayed
NoInsNotReady
Yes During Inserting System if this Zone is in alarm is Prevented the same Plant Equipment
No The system can be armed (see "Type Exclusion" and " Forced Ins. ") even if this Zone is in
alarm during insertion system
Zone Type Snapshot The Zone, in case of unbalance, generates an alarm Immediatly
Delayed The Zone, in case of unbalance, generates an alarm after delay time
Firefighting ALWAYS armed Zone, every unbalance generates an alarm
Antirobbery ALWAYS armed Zone, every unbalance generates an alarm
No Panic ALWAYS armed Zone, every unbalance generates an alarm
24H ALWAYS armed Zone, every unbalance generates an alarm
Technological ALWAYS armed Zone, every unbalance generates an event, never alarms
Follow/Chase If the Zone that must be chased is at rest the other one behaves as "Snapshot"
Alarm Cycles (NoConfig,0..127) Alarm cycles after which the alarms of the Zone will be ignored for that specific insertion,
however they will continue to be saved into the Log
Areas (Area1..Area12) Configuration of the areas the Zone belongs to
And/Or AND The Zone is inserted if ALL AREAS it belongs to are armed
OR The Zone is inserted if LEAST one AREA it belongs to is armed
Test Yes Every alarm generation does not trigger any Event , but only Log
No Every alarm generation triggers both Events and Logs
ZoneToChase (Zone1..Zone73) If the zone is “following” type, this parameter indicates the zone that must be followed
(RadioZone1..
RadioZone64) If the zone is “following” type, this parameter indicates the Radio zone that must be
followed
RF ID Module (NoConfig,1..64) Radio module that is associated with this Radio Zone
RF Mod. Input (1...2) Input of the radio module that is associated with the Zone RADIO:
1
→ magnet / NC / Infrared
2 → shutter / NC / Inertial
Input Type All/Rip The radio module communicates both the alarm and resting Zone (Dip Switch 4 to ON)
Only Alarm The radio module communicates ONLY the Rest Zone (Dip Switch 4 OFF)
Outputs
OK
Install Menu
3)Radio Zone
OK
Radio Zones
Radio Zone 1
Radio Zone 1
Enabled
Output 1
Enable
OK
OK
3)Outputs
Output 1
Menu Install
4)Outputs