Panel Functions 87
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX
Operator’s Manual SOLID 166E
Edition 1.1
5.27. Number of Characters per Inch Setting (Character Spacing)
This function sets the number of characters per inch. This setting is
effective only in case of using a line printer emulation.
With a small number of characters per inch, character spacing will be
relatively large. (Ref. IDOL Programming Manual).
Panel display
[SOLID 166E ]
[Menu Level 1
]
(
(
(
[Page Menu
]
[Font Number
]
(
(
(
[Char. Spacing
]
[Digit4 013.3
]
(
(
(
[Digit1 012.0 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until [Page
Menu ] is displayed.
Press the NEXT or PREVIOUS key until [Char.
Spacing ] is displayed.
13.3 cpi = currently set value.
(
c
haracters
p
er
i
nch).
Pressing the PLUS or MINUS key changes the
value of the current digit (Digit 4 = left
position, in this example: 0.
Pressing the NEXT key moves you to the next
digit (the PREVIOUS key moves you back, if
need be). You can use the number block to set
the function value, too.
The number of characters per inch
was reduced to 12 cpi.
In addition this new value can be saved as
setup value (using the ENTER key), before the
printer is turned ON LINE again.
