MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 37 / 60

Preparing the U-rods
The U-rods for the fins are a design element, which can also be modified.
You need at least two 70mm rods with 1mm diameter.
- Bend them with round nose pliers to the U-shape you can see on the pictures. The distance
between both ends is 5.5mm.
The next pictures show advanced U-rod designs . Some 2mm diameter tubes were added.
These U-rods can be combined with the fins from the mb-sabers.com shop.
- Install the U-rods together with the fins.
-
Add a M2 nut or a 3mm long threaded spacer to each threaded rod to hold the fins in place.
Hand-tighten each nut.
- Install the short rods into the lower fin holes. The rods should be 35-37mm long.
- Add the 3D printed Part03 or the 1mm steel fin with the 5mm threaded spacer.
37