MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 13 / 60

5.
Check the metal printed parts (especially standard steel)
After the printed parts arrive, they must first be inspected.
Most materials do not pose a major problem. However, parts printed from standard steel materials
may have imperfections. Nylon or precious metal parts shouldn't cause any problems.
Check all parts for:
- closed / blocked holes (try to push rods through each hole)
If there is a blocked hole make a picture (for Shapeways) before you do anything else.
If it is not possible to resolve this
issue by drilling or other
techniques please contact
Shapeways and reclaim the part.
They will reprint the part for you.
Use this text:
I know the printing process. I
know it is possible to get a
perfect print result with this
model.
It looks like the print was not
checked and cleaned properly
after the first step before the part goes through the infusion process.
- bent geometry
If the object does not fit because of bent geometry try to reshape it. Steel material is brittle. So
you have to be careful.
First take pictures of the
non-fitting part (for
Shapeways) . Then try to
reshape it.
In most cases it is
possible to make it fit
again. If it is not possible
then please contact
Shapeways and reclaim
this part. Send them the
picture of the issue and
ask for a reprint. They will
reprint this part!
13