MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 21 / 60

Assembling the speaker chamber
1. Install the two M2 rods into Part05 first!
2. Add the four prepared 1.2 mm rods to Part05
3. Add the LED spacer and the chamber to Part05 and mount it with three M1.2 screws
4. Glue (12x) 8mm long 1mm rods into the indentations on the chamber side. Use Loctite 648!
Preparing the Speaker rim cover
The speaker ring covers the speaker rim. It also holds the
speaker and the Part08 in place. It consists of two metal rings.
The first one is smaller. It is placed inside the Part08. It has to be
adapted to the inner diameter of Part08. Sand the outside of
the ring evenly till it fits into the cover.
Slide the Part08 over the chamber. Add the first ring and push it
in the cover onto the chamber. Ring and Part08 should now
have the same level!
Make sure Part08 and the ring are rotated correctly. All holes
line up.
Place the second ring onto the first. Make sure it is rotated
correctly too.
Add 4x M1.2 nuts to each chamber frame rod and screw them
down.
Now match the outer edge of the ring to the radius of Part08.
Use a rotary tool with grinding head and sandpaper.
21