MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 31 / 60

Accent LED/Pixel
Preparing 5050 RGB Pixel LED
Because there is not much space for accent
LED/Pixel, single pixel without PCB have to be
used.
In this case a common LED SMD 5050 RGB
WS2812B is used.
Solder the wires as shown in the picture
Din: AWG 30
VCC: AWG 28 – AWG 30
GND: AWG 28 – AWG 30
capacitor: 100uF
resistor: 330 Ohm
Crystal chamber 5050 RGB Pixel installation
Add the wired pixel to both crystal holder.
The picture shows the position of the 5050 pixels...
Glue them in.
The wires pointing up! (Not shown in the pictures)
Make sure the solder pads do not touch the metal parts!
Insulate them with liquid rubber!
You can glue a 10mm washer onto Part02D for a nicer look.
31