MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 24 / 60

Preparing nylon insulation parts
Separate all three nylon insulation parts and sand down the
grainy surface.
The insulation parts for the positive
pole contact needs special attention!
First sand down the red marked face
of the bottom part till it lines up with
the contact plate surface!
Then sand down the red marked face
of the top part. Make it nice and thin.
Preparing and wiring the battery contacts
Both contacts are available at www.mb-sabers.com
1. Flatten the hooks of the
spring-contact with pliers.
2. Remove the T-bar of the
flat-contact
3. Solder PTFE wires (AWG 28 and AWG22) to the contacts as shown on the picture below.
Solder the wires to the bottom of the flat-contact and to the top of the spring-contact .
4. Glue the contacts onto the nylon parts. Also glue on the flat contact cover.
Use Pattex EXTREM or Epoxy
5. Attach a thin self-adhesive mirror film to the back of the flat-contact.
24