MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 47 / 60

Tech-details
Remove the sprues from the Part01 SPG tech-details .
Put all three tech-details loose over the already attached spacer/steel rods.
Electric wire guide tubes
Add three thin walled steel tubes (3mm
diameter) to Part01 SPG back.
Make sure the ends are smooth without
sharp edges. Otherwise electric wires
could get damaged!
Attach them with screw-lock medium to
hold them in position.
Add Part01 SPG front to the Plasma Gate.
Add washers and nuts. Fasten the nuts. The
Plasma Gate should now look like that:
Motor-holder
The motor-holder holds the small electric motor in position.
It also houses one of the two bearings.
This bearing is not absolutely necessary. The SPG works
also without it. All parts will be assembled without glue!
It is important to (carefully) sand off the grain on the printed Motor-holder surface!
Check the fitting of the motor and the motor-holder itself. The motor should slip in with medium
pressure as well as the holder. But do not make both parts fit loose!
Magnet and motor installation
Use a small 6mm diameter electric motor with attached gear.
Depending on the manufacturer, the motors have different shaft diameter. Some have 2mm
others have 1.5mm or less.
The spinning “Magnet” has a 1mm hole.
Adjust the hole size to the shaft size.
The shaft should slip in with medium pressure. But do not make it fit loose! The shaft will not be
glued into the “magnet”!
If the shaft fits loose, use small round pliers to press the Nylon-shaft slightly flat. This makes the
shaft fit tighter.
47