MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 35 / 60

Oled display installation
1. Solder AWG 34 wires to the four pads in PCB direction .
2. Insulate the solder pads with liquid rubber and adhesive
film.
3. Apply thin double sided adhesive film to the top end of
the Oled window as marked in the picture in red.
4. Apply Pattex extreme repair glue (or similar) to the long
sides of the Oled PCB .
5. Push the Oled display into the frame
This is how the attached
Oled display and accent
LEDs should look like...
Oled display cover
Do not separate the two Oled cover! Use one as grip while sanding down the other one.
The red marked faces (Oled cover underside) must be sanded down to the edge.
After that the two parts can be separated.
Adapt the size to the Oled frame. Then lay it onto the display. Add some (a needle tip)
Loctite 648.
Let it flow between the Oled cover and Part06.
35