MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 28 / 60

Preparing the SMD charge LED
You need a 0605 Bi-color SMD LED (usually green/red).
Add 5cm AWG 34 wires to the four solder pads.
Depending on where the LED will be placed, glue it into the Part 06 LED holder or not.
Wiring the indicator LED to the charge PCB
Solder the four AWG 34 LED wires to the pads on
the charge-PCB as shown on the picture.
The wires should be twisted and be at least 4cm
long!
Apply liquid rubber to the solder joints on the LED
and PCB for more stabilization.
The PCB should now look like this:
28