MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 20 / 60

Preparing the speaker chamber LED-SPACER
The spacer guides the speaker chamber's accent LED light.
Remove the blue foil from the
LED spacer.
This part does not have to be glued. Just place it between part 05 and the speaker chamber.
Attach a thin self-adhesive mirror film to the side facing the chamber. Cut out a 5mm x 5mm area
in the center.
Cut two notches into the LED spacer like shown on the picture. Use the rod guides on the chamber
to find the correct position! Make sure 1mm rods fit and slide easy through the guides, notches
and holes!
Preparing the speaker chamber frame rods
The speaker chamber is framed by four
1.2mm rods.
Use four 1.2mm rods and cut M1.2
threads to each end.
(Or use 1.2mm pre threaded rods
LINK )
1. Cut four 1.2mm rods to 2.5cm length.
2. Tap a thread on one end of each rod.
3. Screw them onto Part05, add the
speaker chamber and speaker ring. Adjust
the length of both ends of each rod.
4. Tap the other end of each rod.
20