MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 43 / 60

Plasma Gate 2.0
The plasma gate is only available for mb-Sabers´ EMITTER Blade holder.
Additional parts for the plasma gate 2.0
- 35mm poly-carbonate tube with 10mm outer diameter
- 3x 35mm aluminum, steel or brass tubes with 3mm outer diameter
- plastic wrap / clingfilm
- 3mm LED, 5mm LED or pixel LED / Pixel ring
- LED holder / Pixel ring holder
The Part01 Plasma Gate 2.0 part has supporting sprues . These
sprues have to be removed (picture on the right)!
The cast metal version does not have supporting sprues!
After removing the sprues, the deluxe details (tube holder) can
be installed . Glue them into position.
Also remove the sprues from the
three Plasma Gate
tech-details
and put them in position.
After that install the three 3mm
wire guide tubes . Glue them
into position.
Additional brass wire details
The final step is to add metal wires as shown
in the picture. There are holes in the
tech-
details part and the plasma gate main part.
These holes can be used to install the metal
wires . There is no general way to add them.
The picture shows an example.
43