#
Place a screwdriver into recesses
2
and
then prise off covers
1
.
#
Using the wheel wrench from the vehicle tool
kit, unscrew the now visible bolts anti-clock‐
wise by approximately 20 turns.
#
Slightly raise spare wheel carrier
4
and
unhook left-hand safety hook
3
.
#
Assemble the pump lever for the jack and
slide it into sleeve
5
on the right-hand side
of spare wheel carrier
4
.
#
Raise the spare wheel carrier with the pump
lever and unhook right-hand safety hook
3
.
#
Position loop
7
of extraction device
6
on
the spare wheel so that you will later be able
to attach wheel wrench
8
.
#
Prepare the jack.
#
Place the jack beneath the corresponding
jack support point.
#
Move the pump lever up and down until the
tyre is raised a maximum of 3 cm off the
ground.
#
Hook wheel wrench
8
into loop
7
of
extraction device
6
on the spare wheel.
#
Carefully remove the spare wheel from spare
wheel carrier
4
. The spare wheel is heavy.
When the spare wheel is removed, the centre
of gravity changes due to the heavy weight of
the wheel. The spare wheel may slip down or
tip over.
#
Remove the spare wheel extraction device
and store it in a safe place. You can now fit
the spare wheel to your vehicle.
#
Lower the vehicle.
Vehicles with rear wheel drive: fitting the
spare wheel (vehicle with lowered chassis)
%
In the event of a flat tyre, you may store the
defective wheel inside the vehicle only. An
intact wheel may be stored in the spare
wheel carrier only when the vehicle is unla‐
den. A laden vehicle must first be raised.
#
Carefully place the spare wheel onto spare
wheel carrier
4
. The spare wheel is heavy.
When you place the spare wheel onto spare
wheel carrier
4
, the centre of gravity
changes due to the weight of the wheel. The
spare wheel may slip down or tip over.
#
Slide the pump lever for the jack into sleeve
5
on spare wheel carrier
4
.
#
Raise spare wheel carrier
4
with the pump
lever and attach right-hand safety hook
3
.
#
Slightly raise spare wheel carrier
4
and
attach left-hand safety hook
3
.
#
Pull the pump lever out of sleeve
5
.
#
Using the wheel wrench, tighten safety hook
bolts
3
by turning them clockwise.
#
Replace and engage covers
1
.
#
Close the rear-end doors.
Removing the spare wheel in the load com‐
partment
#
Release clamping strap
1
by opening the
ratchet.
#
Carefully remove the spare wheel from
bracket
2
.
Fitting the spare wheel in the load compart‐
ment
#
Place the spare wheel in bracket
2
and
press it onto the wall.
#
Tighten clamping strap
1
with the ratchet.
346 Wheels and tyres
Содержание Sprinter 2018
Страница 1: ...Sprinter Operating Instructions Mercedes Benz Sprinter Operating Instructions...
Страница 7: ......
Страница 9: ...Windscreen wipers 97 Rear window wiper 97 At a glance Cockpit 7...
Страница 22: ...CVehicles with rear wheel drive chock DSpare wheel example 342 20 At a glance Emergencies and breakdowns...