Memjet MACH X, Руководство оператора

Страница: 54 / 125

SECTION 3
OPERATING THE PRINTER
48
Layout Tab
Layout allows you change how the document
prints without changing the original document.
•
Resizing – Lets you specify the
Original Size or Custom Resize: lets
you resize the original as a % of normal
size. The Printer will print the document
in the size you selected regardless of the
size of the paper selected.
Print on: lets you specify the particular
size of paper that you want to print on
regardless of the size of the original
document.
Checking “
Scale to Fit ” automatically
resizes the document to fit on the new
page size.
•
Printing Adjustments – Allows you to
make minor changes to the print position
and print area; in relation ship to the
media feed direction.
Units (measurements) can be set to
Inches , Millimeters or Pixels .
Tip: You will need to use these features to positoin the image on the label; particularly when
doing “full-bleed” printing. When you switch between unit selections; numbers are rounded to the
nearest pixel.
NOTE : The values entered, in the following adjustments, do NOT override the values set in the
Toolbox (User Interface and Service Menus - Printer Control Config). Instead, the values entered
are added to or subtracted from the values set in the Toolbox. The range values (min and max),
provided below, assume that the Toolbox values for “tof_adjustment” and “left_adjustment” are
set to zero (0).
Exceeding these min or max values may cause the printer to print nothing (feed the media blank).
o
Left Adjustment – Lets you shift the printed image left or right.
Range: -3mm left to +200mm right. Default = Zero (0)
negative value = shift left (towards non-operator side)
positive value = shift right (towards operator side)
Zero (0) = left edge of media; if Media Registraion Side Guid is set to “inner position”.
o
Max Page Width – Lets you limit how wide the actual print area will be. This feature can
be used to “cut-off” the right-side (operator side) of an image; at a set position. It also
shuts off the keep wet spitting (KWS) function, in the “cut-off” area, saving ink.
Range: 0.5mm to 220.8mm. Default = 220.82 mm (full print width)
o
Top Adjustment - Moves the image up or down on the media/label.
Range: -5mm up, to 200mm down. Default = Zero (0)
negative value = shift up (towards leading edge)
positive value = shift down (towards trailing edge)
Zero (0) = leading edge of media.