Memjet MACH X, Руководство оператора

Страница: 12 / 125

SECTION 1
GETTING ACQUAINTED
6
Winder
1.
Speed Control – Turn clockwise to speed up, counterclockwise to slow down.
2.
ON/OFF Mode Switch – Use to turn Winder power ON or OFF.
3.
Fuse – Winder fuse is located here.
4.
Hub Assembly/Guide – Holds the core. Fits 3" cores.
5.
Spindle Lock/Guide – Holds the label/media roll in place on the Spindle.
6.
Label Roll Spindle – Used to wind the Printed Media around an empty core.
7.
Label Tension Arm – Position of spring-loaded shaft controls stopping/starting and rotation
direction of Winder; as tension is maintained or released by media web. Adjust spring tension
using the Tension Control Selector [10].
8.
Media Guide Ring – Slides to fit width of media.
9.
Winder Alignment Notch – Aligns with the notch on the Spacer Plate mounted on the Printer.
Plate is then attached to Winder to keep the Printer and Winder properly aligned.
10.
Tension Control Selector – Increases or decreases the spring tension on the Label Tension Arm
to accommodate different media widths.
Narrow media requires lower tension (0). Wide media requires higher tension (4).
11.
24V, 2.5A External Power Connector* – For connecting printers or equipment other than the
Mach X.
NOTE: External power supply must be a UL Listed power supply.
*Requires disconnecting wire from Winder circuit board and connecting wire from External
Power Connector.
12.
Winder Interconnect Cord – Connects Winder to Printer.