Memjet MACH X, Руководство оператора

Страница: 19 / 125

SECTION 2
INSTALLING THE PRINTER
13
Choosing the Location
The Printer should be placed on a sturdy level worktable or cabinet at least 9 inches from any walls.
The surface should be large enough to accommodate the Printer, and Unwinder and Winder if used, in
a line together. Protect the Printer and the Unwinder/Winder from excessive heat, dust, and moisture.
Avoid placing it in direct sunlight
Work-Table Surface Must be Level
IMPORTANT! The s urface that the printer is placed upon must be level, front to back and side to
side. Use a carpenter’s level (bubble level) to verify that the surface is level. If the surface is not level
the printer will not perform properly; which can lead to damage not covered under warranty.
NOTE : If equipped; you can use the “Bubble
Gauge”, mounted on the Print Engine, to verify that
the printer is level.
Why is this Important?
The printer’s ink monitor/delivery systems and waste
ink drainage system depend on the printer being level
to perform properly. If this rule is not followed you
will experience print quality issues, premature visible
“Ink Out” conditions and waste ink drainage issues
that could cause damage to the printer and void the
warranty.
-
Level the table surface to level the printer.
-
Do NOT shim, raise or otherwise modify the printer, or feet of the printer, in any way.
-
If the table surface cannot be leveled then the printer should not be placed on it.
-
If the table is not sturdy then the printer should not be placed on it.
-
Do NOT use the Toolbox utilities “Tilt” readings to level the printer or table.
-
Use an accurate level (i.e. bubble level that is at least 18” long), to check that the table surface is
level (front to back and left to right). It is not acceptable to use your “cell phone app” to check
level.
-
Do NOT move the printer while the power is on.
Operating Conditions
Operation should take place under the following conditions:
- At temperatures b15°C and +35°C (59 °F to 95 °F).
- At a relative air humidity between 20% and 80%, non-condensing.
- At an atmospheric pressure between 70 kPa and 105 kPa.
- Printer and Print Engine should be protected from excessive environmental debris/dust.
- Printer must be placed on a “Sturdy/Level” surface.
Exposure to conditions that are not permissible may lead to damage which is not externally visible.
Allow the printer, printhead and ink tanks to acclimate to ambient temperature before using the printer.