MA-5151-ENG
PATTERN CONTROLLER STARBI
USE
4-19
26.
ADVANCED PARAMETERS
screen.
These parameters are configured in the same way as the products by times
but with values in millimetres (mm). The analogue outputs are configured in
ramp mode to have a variable output depending on the speed.
27.
VARIABLE PRODUCT BY DISTANCE
screen.
The screen appears when you name a new product from the NEW PRODUCT
screen or if you select an existing one from the EDIT PRODUCT screen. The
first thing that is selected is the installation followed by the photocell. The
other parameters are configured with values in millimetres (mm), as in
VARIABLE PRODUCT BY TIME (page 4-15).
A- The distance between photocells and applicators is determined by
the installation.
B- Only one bead for each pattern is defined. The bead is configured by
its start (ON) distance, its end (END) and if it has dotting or not.
ON: This is the DISTANCE from which the photocell DETECTS the
product until it STARTS to apply adhesive.
OFF: This is the DISTANCE from which the photocell STOPS
DETECTING the product until it STOPS firing adhesive.
STARBI.
i
10
5
0
0
50
100
m/min
voltio
P1
0.0
5
P2
5
10
P3
P4
P5
Product 0
Analog output 1
STARBI.
i
Dot bead
Continue after stop
Pallet mode
Analog output 1
Analog output 2
FC Disable
0.0
mm.
P
0.0 mm.
Off
0
S
0.0 mm.
On
0
Product 0
A- If during the execution of a
product the production line
stops (READY status) it is
possible to choose when the
situation is restored, continue
executing the pattern,
continuing from the point
where it stopped, or cancel the
current pattern and wait for a
new product.
B- Machine speed with which you
want to associate an output
voltage value of between 0 and
10 V.
C- Output voltage of the analogue
signal associated with a
certain machine speed.
A
B
C
!
!
STARBI.
W
i
10
10
1
2
3
4
5
6
P1
Product 0
Select your FC
Select your isntallation
Unit: ms
A
B
!