INSTALLATION
3-5
MA-5151-ENG
PATTERN CONTROLLER STARBI
3. Input for encoder
When using ‘speed reading’ (programming by DISTANCES) it is necessary to
have a pulse generator component or analogue input of 0-10 V to know the
speed of movement of the substrate.
If using an ‘encoder’, the connection is made with an M12 4-pin connector with
mounting thread.
1 24Vdc
2
signal (PNP type)
3
0 V
4
screen mesh
4. Input for 0-10 V signal
If using a ‘0-10 V signal’ for speed reading, the connection is made with an
M12 5-pin connector with mounting thread.
1
+ V
2 s/c
3
0 V
4
s/c
5
screen mesh
5. Output for 0-10 V signal
The 0-10 V signal can be used to regulate, by means of a transducer (pro-
portional valve), the application or by-pass valve pressure, depending on the
speed of the substrate. For this, output 4.2 is connected (see Introduction
chapter, page 2.5).
The connection is made with an M12 5-pin connector with mounting thread.
1
+10 V
2 s/c
3
0 V
4
s/c
5
screen mesh
It can also be used to directly control an activator device, e.g. speed of a motor
of a dispensing pump, and in this case the isolated output 4.1 will be used (see
Introduction chapter, page 2.5).
The connection is made with an M12 5-pin connector with mounting thread.
1
+10 V
2
+24 V
3
0 V
4
s/c
5
screen mesh
0
V
0
V
0
V
3
2
4
1
5
3
2
4
1
3
4
1
2
5
3
2
4
1
5