Matsusada DOEF Series, Инструкция по эксплуатации

Страница: 101 / 124

7 Synchronized operation option
93
DOEF series
Matsusada Precision
7 Synchronized operation option
(Synchronous trigger and synchronous clock)
The unit has a synchronous trigger function and synchronous clock function, which allow multiple units to be
synchronized.
There are two types in synchronized operation: synchronous trigger function and synchronous clock function.
Those functions work between models with different outputs. They can also be controlled in different settings
(one for normal operation and the other for sequence operation).
As the synchronous triggering and synchronous clock functions are separate functions, they can be used
individually.
[Synchronous trigger]

Operating the synchronous master unit allows the output to be turned on or off simultaneously.

The gap between the synchronous master unit and the next synchronous slave unit when the output is on
is
0.5μs (reference value).

Sequence operation is also possible to start/stop simultaneously. The gap for the sequence operation is
also 0.5μs (reference value). For the connection, use the D-Sub connector on the rear panel.
[Synchronous clock]

Using a common clock enables the waveform frequency to match each other. In addition, the step time for
sequence will match each other as well.

For the connection, use the BNC connector on the rear panel.

The synchronous clock can be connected up to three units.
[Connector]
The gaps in output ON and sequence operations are reference values for the same settings,
not guaranteed values.
It is possible to connect other instruments that can be synchronized with a 10 MHz clock, but it is not
guaranteed to work with them other than DOEF series.
When the master/slave operation (parallel operation) option is used, synchronous operation is not available.
For synchronous trigger
D-Sub 15-pin, female
Synchronous CLK IN (BNC
）
Synchronous CLK OUT (BNC)