[Not using SUZUKI scan tool]
1) Check malfunction indicator lamp (1) referring to MALFUNC-
TION INDICATOR LAMP (MIL) CHECK in this section.
2) Using service wire, ground diagnosis switch terminal in monitor
coupler (2).
3) Read DTC from flashing pattern of malfunction indicator lamp.
Refer to DTC TABLE.
If lamp remains ON, go to Table A-3 in this section.
NOTE:
If abnormality or malfunction lies in two or more areas,
malfunction indicator lamp indicates applicable codes
three times each.
And flashing of these codes is repeated as long as diag-
nosis terminal (3) is grounded and ignition switch is held
at ON position.
Take a note of diagnostic trouble code indicated first.
4) After completing the check, turn ignition switch OFF and discon-
nect service wire from monitor connector.
6E1-12
ENGINE AND EMISSION CONTROL SYSTEM
EXAMPLE: When throttle position sensor is defective (Code No. 13)
Содержание 800
Страница 354: ...UNIT REPAIR OVERHAUL ENGINE ASSEMBLY REMOVAL AND INSTALLATION Refer to Section 6A ENGINE MECHANICAL F8D ENGINE 6A1 51 ...
Страница 396: ...6E1 6 ENGINE AND EMISSION CONTROL SYSTEM ...
Страница 423: ...ENGINE AND EMISSION CONTROL SYSTEM 6E1 33 Blank ...
Страница 644: ...Prepared by Overseas Service Department 1st Ed October 1999 Printing 646 ...