MARUTI SUZUKI 800, Руководство по обслуживанию

Страница: 325 / 644

2) Install oil pump strainer (1) and oil pan (2).
Install new O-ring (3) to oil pump strainer in the position as
shown in figure.
Install strainer to cylinder block, then tighten strainer bolt to spe-
cified torque.
Tightening Torque
(a): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
After fitting oil pan to cylinder block, run in securing bolts and
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts to specified torque.
Tightening Torque
(b): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
(b)
3) Install new gasket and drain plug (1) to oil pan.
Tighten drain plug (1) to specified torque.
Tightening Torque
(a): 50 N
.
m (5.0 kg-m, 36.5 lb-ft)
4) Install clutch (torque converter) housing lower plate.
5) Connect exhaust manifold pipe to exhaust manifold.
6) Refill engine with engine oil, referring to item ENGINE OIL
CHANGE in Section 0B.
7) Verify that there is no engine oil leakage and differential oil leak-
age at each connection.
6A1-22 ENGINE MECHANICAL (F8D ENGINE)