Manitou MLT 845 120 LSU 3-E3 Series, Руководство оператора

Страница: 118 / 128

4-7 4-7
3 3
C - HYDRAULIC C - HYDRAULIC A A TT TT ACHMENT AND HAND ACHMENT AND HAND LOCKING DEVICE LOCKING DEVICE
TAKING UP AN ATTACHMENT TAKING UP AN ATTACHMENT
- - Ensure that the attachment is in a Ensure that the attachment is in a position facilitating the locking to the carriage. If it is position facilitating the locking to the carriage. If it is
not correctly oriented, take the necessary precautions in order to move it safely. not correctly oriented, take the necessary precautions in order to move it safely.
- Check that the locking pin and the clip are in position in the bracket (fig. A). - Check that the locking pin and the clip are in position in the bracket (fig. A).
- - Place the lift truck with the jib fully lowered in front of and parallel to the Place the lift truck with the jib fully lowered in front of and parallel to the attachment, tilt attachment, tilt
the carriage forwards (fig. B). the carriage forwards (fig. B).
- - Bring the carriage under the locking tube of the att Bring the carriage under the locking tube of the att achment, slightly lift the jib, incline the achment, slightly lift the jib, incline the
carriage backwards in order to position the attachment (fig. C). carriage backwards in order to position the attachment (fig. C).
- Lift the attachment off the ground to facilitate locking. - Lift the attachment off the ground to facilitate locking.
MANUAL LOCKING AND CONNECTION OF THE ATTACHMENT MANUAL LOCKING AND CONNECTION OF THE ATTACHMENT
- - T T ake the locking pin and the clip on the bracket (fig. A) and loc ake the locking pin and the clip on the bracket (fig. A) and loc k the attachment (fig. D). k the attachment (fig. D).
Do not forget to refit the clip. Do not forget to refit the clip.
- Stop the I.C. engine and keep the ignition on the lift truck. - Stop the I.C. engine and keep the ignition on the lift truck.
- - Remove the pressure of the hydraulic circuit by operating switch 1 (fig. E) o Remove the pressure of the hydraulic circuit by operating switch 1 (fig. E) o n the distributor n the distributor
lever backwards and forwards 4 or 5 times. lever backwards and forwards 4 or 5 times.
- - Connect the rapid connectors Connect the rapid connectors according to the logic of the attach according to the logic of the attach ment’s hydraulic ment’s hydraulic
movements. movements.
Make sure that the rapid Make sure that the rapid connectors are clean and protect the holes which are connectors are clean and protect the holes which are not used, with the caps not used, with the caps
provided. provided.
HAND RELEASING AND DISCONNECTING THE ATTACHMENT HAND RELEASING AND DISCONNECTING THE ATTACHMENT
- - Proceed in the opposite order to that described in MANU Proceed in the opposite order to that described in MANU AL LOCKING AND CONNECTION AL LOCKING AND CONNECTION
OF THE ATTACHMENT while making sure you put the locking pin back into the bracket (fig. A). OF THE ATTACHMENT while making sure you put the locking pin back into the bracket (fig. A).
LAYING AN ATTACHMENT LAYING AN ATTACHMENT
- - Proceed in the reverse order of paragraph TAKING UP AN A Proceed in the reverse order of paragraph TAKING UP AN A TTACHMENT while making sure TTACHMENT while making sure
you place the attachment flat on the you place the attachment flat on the ground and in closed position. ground and in closed position.
A A
B B
C C
D D
E E
1 1
https://www.forkliftpdfmanuals.com/