Manitou MLT 845 120 LSU 3-E3 Series, Руководство оператора

Страница: 23 / 128

1-19 1-19
TAKING UP A HIGH LOA TAKING UP A HIGH LOA D ON STABILIZERS D ON STABILIZERS
- Make sure the forks will fit easily under the load. - Make sure the forks will fit easily under the load.
- - Check the position of t Check the position of t he lift truck with respect to the load and he lift truck with respect to the load and make a test run, if make a test run, if
necessary, without taking the load. necessary, without taking the load.
- Raise and extend the jib - Raise and extend the jib (1) (2) until the forks are at (1) (2) until the forks are at the level of the load the level of the load (fig. G5). (fig. G5).
- - Block the forks in front Block the forks in front of the load by alternately using the of the load by alternately using the controls to extend and lower controls to extend and lower
the jib (1) (fig. G6). the jib (1) (fig. G6).
- Lift the load slightly (1) and tilt the carriage (2) backwards to stabilise the load (fig. G7). - Lift the load slightly (1) and tilt the carriage (2) backwards to stabilise the load (fig. G7).
- - Monitor the longitudinal stability alarm (see Monitor the longitudinal stability alarm (see : INSTRUCTIONS : INSTRUCTIONS FOR HANDLING A LOAD: C FOR HANDLING A LOAD: C
- LONGITUDINAL STABILITY ALARM). If it is overloaded, set the load down in the place from - LONGITUDINAL STABILITY ALARM). If it is overloaded, set the load down in the place from
where it was taken. where it was taken.
- - If possible lower the load withou If possible lower the load withou t moving the lift truck. Raise the jib ( t moving the lift truck. Raise the jib ( 1) to release the load, 1) to release the load,
retract (2) and lower the jib (3) to set the load into transport position (fig. G8). retract (2) and lower the jib (3) to set the load into transport position (fig. G8).
LA LA YING A HIGH YING A HIGH LOAD ON LOAD ON STABILIZ STABILIZ ERS ERS
- - Raise and extend the jib (1) (2) un Raise and extend the jib (1) (2) un til the load is above the elevation (fig. G9), while til the load is above the elevation (fig. G9), while
monitoring the longitudinal stability alarm monitoring the longitudinal stability alarm (see: INSTRUCTIONS FOR HANDLING A LOAD: C (see: INSTRUCTIONS FOR HANDLING A LOAD: C
- LONGITUDINAL STABILITY ALARM). - LONGITUDINAL STABILITY ALARM).
- - Position the load horizontally and release it Position the load horizontally and release it by lowering and retracting the jib (1) by lowering and retracting the jib (1) (2) to (2) to
position the load correctly (fig. G10). position the load correctly (fig. G10).
- Release the forks by alternating - Release the forks by alternating retracting and raising the jib retracting and raising the jib (3) (fig. G11). (3) (fig. G11).
- If possible, set the jib in transport position without moving the lift truck. - If possible, set the jib in transport position without moving the lift truck.
1 1
2 2
G5 G5
1 1
G6 G6
1 1
2 2
3 3
G8 G8
1 1
2 2
G7 G7
1 1
2 2
G9 G9
3 3
G11 G11
1 1
2 2
G10 G10
https://www.forkliftpdfmanuals.com/