Manitou MLT 845 120 LSU 3-E3 Series, Руководство оператора

Страница: 31 / 128

1-26 1-26
1 27 1 27
BRINGING THE LIFT TRUCK BACK INTO SERVICE BRINGING THE LIFT TRUCK BACK INTO SERVICE
- Remove the waterproof adhesive tape from - Remove the waterproof adhesive tape from all the holes. all the holes.
- Refit the intake hose. - Refit the intake hose.
- Refit and reconnect the battery. - Refit and reconnect the battery.
- Remove the protection from the cylinder rods. - Remove the protection from the cylinder rods.
- Perform the daily service (see: 3 - MAINTENANCE: A - DAILY OR EVERY 10 HOURS SERVICE). - Perform the daily service (see: 3 - MAINTENANCE: A - DAILY OR EVERY 10 HOURS SERVICE).
- Put the handbrake on and - Put the handbrake on and remove the axle stands. remove the axle stands.
- Empty and replace the fuel and replace the fuel filter (see: 3 - MAINTENANCE: D - EVERY 500 HOURS SERVICE). - Empty and replace the fuel and replace the fuel filter (see: 3 - MAINTENANCE: D - EVERY 500 HOURS SERVICE).
- Refit and set the tension in - Refit and set the tension in the drive belts (see: 3 - the drive belts (see: 3 - MAINTENANCE: C - EVERY 250 HOURS SERVICE). MAINTENANCE: C - EVERY 250 HOURS SERVICE).
- Turn the I.C. engine using the starter, to allow the oil pressure to rise. - Turn the I.C. engine using the starter, to allow the oil pressure to rise.
- Reconnect the engine cut-off solenoid. - Reconnect the engine cut-off solenoid.
- Lubricate the lift truck completely (see: 3 - MAINTENANCE: SERVICING SCHEDULE). - Lubricate the lift truck completely (see: 3 - MAINTENANCE: SERVICING SCHEDULE).
Make sure the area is adequately ventilated before starting Make sure the area is adequately ventilated before starting up the lift truck. up the lift truck.
- Start up the lift truck, following the safety instructions and regulations (see: OPERATING INSTRUCTIONS UNLADEN AND LADEN). - Start up the lift truck, following the safety instructions and regulations (see: OPERATING INSTRUCTIONS UNLADEN AND LADEN).
- Run all the jib’s hydraulic - Run all the jib’s hydraulic movements, concentrating on the ends of travel for each cyli movements, concentrating on the ends of travel for each cyli nder. nder.
https://www.forkliftpdfmanuals.com/