MaIntenanCe
34
)
Insert the bleeding syringe
(
3
)
tightly into the bleed hole
[
h4
]
.
)
Press MAGURA
Royal Blood
slowly out of the filling syringe
(
2
)
through the brake system – tap lightly on the brake cylinder and
brake lever during this process.
)
Flick the brake lever blade 2–3 times.
Ö
This dislodges air bubbles and they rise into the bleed
syringe
(
3
)
[
h4
]
.
)
Continue the process until you cannot see any more air bubbles.
Ö
The brake system has been bled.
Oil loss when removing the bleed syringe.
Have a clean cloth at hand.
Hold the bleed bore closed before and after pulling off of the
bleeding syringe.
Hold the bleeding syringe with its point upwards after pulling off,
and push in the piston until just beyond the bleed bore.
)
Pull the bleeding syringe out of the bleed hole.
)
Press a little MAGURA
Royal Blood
slowly out of the filling syringe
(
2
)
through the brake system until the bleed hole is just filled.
)
Screw the EBT screw
(
8
)
into the bleed hole and tighten with tight-
ening torque of
0.5 N·m (4 lbf·in)
.
[
h3
]
Oil loss when unscrewing the filling syringe.
Have a clean cloth at hand.
After unscrewing close the filler hole quickly.
Before unscrewing, lift the brake calliper above the level of the
brake lever, if possible.
)
Unscrew the barbed fitting of the filling syringe
(
2
)
from the filler
hole.
[
h2
]
)
Screw the screw plug quickly into the filler hole and tighten with
tightening torque of
4 N·m (35 lbf·in)
[
h2
]
.
)
Remove any oil residues thoroughly.
)
Pull and hold the brake lever blade several times and check:
No oil is leaking from any part of the brake system.
Pressure point is clearly noticeable and does not change.
)
Install brake pads – see
c
hanging
Brake
paDs
, page 32.
)
Install wheel with mounted disc brake rotor or insert transport
device.
[
D1
]
)
Move the brake lever into the customary position and secure
– see
installing brake lever
, page 25.
)
Set the pressure point – see
setting the pressure point
, page 29.
t
h
E
rul
Es
Содержание Storm CL
Страница 2: ......