Magnetek Impulse G+ series 4, Инструкция по эксплуатации

Страница: 62 / 276

IMPULSE®•G+ & VG+ Series 4 Instruction Manual - February 2017
3-22
Safe Torque Off
The Safe Disable inputs provide a stop function in compliance with “Safe Torque Off” as defined in
IEC/EN 61800-5-2. Safe Disable inputs have been designed to meet the requirements of the ISO/EN
13849-1, Category 3 PLd, and IEC/EN 61508, SIL2.
Safe Torque Off disable the drive power section for mechanical maintenance, E-stops, or
redundancy safety monitor controller intervention. The feature provides safe removal of motor torque
without removal of power to the drive. This is a standard feature on the IMPULSE®•G+ & VG+
Series 4. A Safe Disable Status Monitor for error detection in the safety circuit is also provided.
The Safe Disable circuit (Figure 3-16) consists of two independent input channels (H1 and H2) that
can block the output transistors and provide a monitoring output channel (DM+ and DM-) to indicate
the status of those input channels.
The input can use the internal 24VDC power supply of the drive or an external power supply, and it
will support Sink mode or Source mode. The mode selected for the digital input terminals S1 to S8
by jumper S3 will also be used for the Safe Disable inputs.
NOTE: Terminals H1, H2, DM+, and DM- on 575V class models are designed to the functionality,
but are not certified to IEC/EN 61800-5-1, ISO/EN 13849 Cat. 3, IEC/EN 61508 SIL2,
Insulation coordination: class 1.
Inputs/Outputs
Two Safe Disable inputs and one EDM output
according to ISO/EN 13849-1 Cat. 3 PLd, IEC/EN
61508 SIl2.
Operation Time
Time from input open to drive output stop is less than
1 ms.
Failure Probability
Demand Rate Low
PFD = 5.15E
-5
Demand Rate High/
Continuous
PFH = 1.2E
-9
Performance Level
The Safe Disable inputs satisfy all requirements of
Performance Level (PL) d according to ISO/EN
13849-1 (DC from EDM considered).