Magnetek Impulse G+ series 4, Инструкция по эксплуатации

Страница: 175 / 276

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-89
F1 and F2 Keys Function Selection
The F1 and F2 keys on the keypad have the ability of being programmed with specific functions to
imitate digital inputs. The table below displays the various settings, which are valid for these buttons.
• To operate a function assigned to the F1 or F2 key, the respective button must be held down.
Releasing the button will stop the function. Be cautious when operating these keys, and
remember that the STOP key will override and stop all functions.
• To quickly view the functions assigned to both buttons, press the LO/RE key three times.
Table 5-73: F1 and F2 Function Selection Parameter Settings
Table 5-74: F1 and F2 keys function selectable for H01-09 and H01-10
Parameter Display Function Range Default
H01-09 F1 Key Selection Function selection for F1 key 0F–74 0F
H01-10 F2 Key Selection Function selection for F2 key 0F–74 0F
Display Function Instruction Alert/Confirm Message
0F Not Used No function -
terminal is disabled
-- --
48 Flt Latch Reset When a fault is
latched, toggle this
input ON and then
OFF to clear the
fault.
Press F1 or F2 once to pre-
start Fault Latch Reset. A
confirm message will appear,
and the same key press will
be required once more to
reset a latched fault.
Confirm?
Flt Latch Reset
53 Comm Test Mode Communication Test
Mode - loopback test
of Modbus RS-422/
485 interface
Hold down the F1 or F2 key
for 2–3 seconds to initiate the
Comm Test.
Running:
Comm Test Mode
5A MaintenanceReset Resets Maintenance
Timer (C12-05, C12-
06, U01-52)
Press F1 or F2 once to pre-
start Maintenance Timer
Reset. A confirm message will
appear, and the same key
press will be required once
more to reset the
Maintenance Timer.
Confirm?
MaintenanceReset
61 Brake Test Motor pushes
against brake up to
programmable
torque setting C08-
24 at programmable
frequency C08-25.
Disabled PG Faults
during this condition.
Hold down the F1 or F2 key to
initiate the Brake Test.
Running:
Brake Test
67 Hook Height Home Used with C03-14 -
Height Measurement
function.
Press F1 or F2 once to pre-
start Hook Height Home. A
confirm message will appear,
and the same key press will
be required once more to
home the Hook Height.
Confirm?
Hook Height Home
69 LC Bypass N.O. Disables Load
Check and clears
any LC faults.
Hold down the F1 or F2 key to
initiate the LC Bypass.
Running:
LC Bypass N.O.
73 LL2/UL2 Bypass Bypass Limit MFDI
and EPLS
Hold down the F1/F2 key to
initiate LL2/UL2 Bypass.
Running:
LL2/UL2 Bypass
74 LL/UL Bypass Bypass MFDI and
EPLS
Hold down the F1/F2 key to
initiate LL/UL Bypass.
Running:
LL/UL Bypass