Magnetek Impulse G+ series 4, Инструкция по эксплуатации

Страница: 147 / 276

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-61
Torque Control
Please consult factory for application assistance regarding torque control. Typically, torque control
should not be applied on a hoist.
This function is used to avoid excessive changes in torque, which may be caused by abnormal
resonance when the torque reference changes rapidly.
Table 5-48: Torque Control Parameter Settings
NOTE: Speed/torque control selection can also be made by using a multi-function input select
(H01-xx = 34 speed-torque control changeover).
Parameter Display Function Range Default Model
D05-01 Torq Control Sel Determines whether Speed or
Torque Control is selected.
0, 1 0 VG+
0 Speed Control Speed Control enabled with torque
limit
1 Torque Control* Torque control enabled with speed
limit.
D05-02 Torque Ref Filter Primary delay time for Torque
Reference Input.
0–1000 ms 0 VG+
D05-03 Speed Limit Sel Speed Limit Selection (See Figure
5-21)
1, 2 2 VG+
1 Fref Limit Limit set by the frequency
reference in B01-01.
2 Speed Limit Sel Limit set by D05-04.
D05-04 Speed Lmt Value Speed Limit Value (% of
E01-04)
-120–120% 105 VG+
D05-05 Speed Lmt Bias Speed Limit Bias (% of
E01-04)
0–120% 10 VG+
D05-06 Ref Hold Time Speed/Torque Switching Timer 0–1000 ms 0 VG+
D05-08 Drctn SpdLmt Sel Parameter D05-08 selects how the
speed limit bias is applied.
0, 1 1 VG+
0 Disabled
1 Enabled
* Cannot set D05-01 = 1 for NLB Hoist; use Load Share MFDI (H01-xx = 66) instead.