Magnetek Impulse G+ series 4, Инструкция по эксплуатации

Страница: 274 / 276

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
A-20
U01-52 MaintenanceTimer -- -- hr 5-133
U01-53 Index Count -- -- Revs 5-133
U01-54 Term RP Inp Freq -- -- Hz 5-133
U01-60 PG CH1 Count -- -- Pulse 5-133
U01-61 PG CH2 Count -- -- Pulse 5-133
U01-63 PG CH1 Freq -- -- Hz 5-133
U01-64 PG CH2 Freq -- -- Hz 5-133
U01-65 PG Output Freq -- -- Hz 5-133
U01-66 BE6 Pulse Count -- -- Pulse 5-133
U01-68 LC Zone -- -- -- 5-133
U01-69 LC Margin -- -- % 5-133
U01-84 NLB State -- -- -- 5-133
U01-85 NLB Rel Trq -- -- % 5-133
U01-86 Brk Test Trq -- -- Flb 5-133
U02-01 Current Fault -- -- -- 5-133
U02-02 Last Fault -- -- -- 5-133
U02-03 Frequency Ref -- -- Hz 5-133
U02-04 Output Freq -- -- Hz 5-133
U02-05 Output Current -- -- A 5-133
U02-06 Motor Speed -- -- Hz 5-133
U02-07 Output Voltage -- -- VAC 5-133
U02-08 DC Bus Voltage -- -- VDC 5-133
U02-09 Output HP -- -- HP 5-133
U02-10 Torque Reference -- -- % 5-133
U02-11 Input Term Sts -- -- -- 5-133
U02-12 Output Term Sts -- -- -- 5-133
U02-13 Inverter Status -- -- -- 5-133
U02-14 Elapsed Time -- -- hr 5-133
U02-15 SFS Output -- -- Hz 5-134
U02-16 Motor Iq Current -- -- % 5-134
U02-17 Motor Id Current -- -- % 5-134
U02-20 Actual Fin Temp -- -- °C 5-134
U02-27 Motor Temp (NTC) -- -- °C 5-134
U02-28 Fault Axis -- -- -- 5-134
U03-01 Last Fault -- -- -- 5-134
U03-02 Fault Message 2 -- -- -- 5-134
U03-03 Fault Message 3 -- -- -- 5-134
U03-04 Fault Message 4 -- -- -- 5-134
U03-05 Fault Message 5 -- -- -- 5-134
U03-06 Fault Message 6 -- -- -- 5-134
U03-07 Fault Message 7 -- -- -- 5-134
Parameter Parameter Name Default Range Units Reference
* Initial value set by X-Press Programming (Table 4-6, 4-7, or 4-8 on pages 4-12, 4-13, and 4-14).
** Initial value dependent on drive size, which is determined by O02-04 (kVA Selection).
*** Value is automatically set during auto tuning.
**** 0.0–25.5 seconds is extended to 0.0–6000.0 seconds when B05-16 = 1.