Operating Modes
Version 6.03, May 2017
Page 66 of 192
Volume level (loudness) can be also set with volume rotary knob, when alarm is
being played
5.1.7.4
Observation Zones
This menu defines the default observation zone geometry. The following items can be
chosen: start zone, turn point zone, finish zone and templates.
Each type of observation zone is defined with two angles, two radii and mean bearing
(
Angle12
). These parameters enable the creation of any known zone geometry separately
for start, turn point and finish.
All stored tasks will match this “global” setting except those where the zone was modified in
the task edit menu (see Chapter 5.7.2).
Using parameters in the zone dialogue it is possible to describe all types of observation
zones.
Angle12
defines the orientation of the observation zone. Available values for
Direction
are:
Symmetric:
This is the most common selection for turn point.
Fixed
: This is mostly used for assigned areas.
Next:
will orient the observation zone in direction of the outgoing leg. This is usually
used for start.
Prev:
will orient the zone in direction of the incoming leg and is usually used for the
finish.
Start:
orientates the sector always towards the start.