Navigational page layout
Version 6.03, May 2017
Page 141 of 192
Press button
MEM 1
for a long time. A message
“Options stored to memory (1)”
will be
displayed and the settings are stored. Change the settings a little bit. Press button
MEM 2
for long time. A message
“Options stored to memory (2)”
will be displayed and the settings
are stored to memory location 2. Now short pressing of
MEM 1
will invoke the saved
settings from memory 1.
6.2.1.3
Wind
The main display unit constantly calculates winds using four different methods.
Speed
difference
method is used during circling and is taking into account ground speed
difference in a single circle.
Position drift
is calculating wind based on position drift during
circling. A minimum of three circles must be completed to obtain the first wind
measurements. The third method is
combination
, which takes into account also airspeed
received from the vario unit.
If the
compass
module is available wind is also estimated using the wind triangle.
Calculated wind is stored in layers. Layer height is 300 m or 1000 ft and cannot be modified
by the user.
On rear seat device there is additional method called
front seat.
When
front seat
method
is selected, device will use wind calculated by front seat only and all other methods will be
disabled. This will ensure that both devices are using same wind for final glide calculations.
The wind profile is shown on the left side of the dialogue. Yellow coloured altitude indicates
our current MSL altitude. Using the ZOOM selector knob you can scroll up and down
through the wind layers.
