LumaSense SmartDGA, Руководство по оборудованию

Страница: 85 / 114

SmartDGA Hardware Manual Maintenance
•
85
3. Removed the bottom “U-shaped” panel using a medium Phillips head screwdriver.
Save the (5) screws.
Note:
You may need to use a small Flat head screwdriver in order to remove this panel
if it is tight.
4. Locate the battery directly above the 5-pin “SERIAL” connector.
5. Remove the old battery by pushing down on the retention tab and then sliding the battery
straight out.
Caution: Use rubber gloves or other protection when handling the new battery, as
finger prints can reduce the battery’s life span.
6. Insert the new battery into the holder with the positive side facing
down (toward the “SERIAL” connector).
7. Reattach the “U-shaped” and small access panels.
8. Reconnect the iCore unit and bring the system back online.
9. Using the touchscreen, navigate to the Battery Life software screen and press the Reset
button.