LumaSense SmartDGA, Руководство по оборудованию

Страница: 84 / 114

SmartDGA Hardware Manual Maintenance
•
84
7. Insert the new battery into the clip with the positive side facing up.
8. Reinstall the left (LTC) side cover and reattach the yellow band.
9. Reconnect the EZHub controller.
7.2.2 Replacing the LumaSMART
i
Core
TM
Battery
Ensure you have the following parts and tools on hand prior to starting installation:
PROVIDED BY CUSTOMER
Qty Description
1 New Replacement Battery
1 Medium Phillips Head Screwdriver
1 Small Flat Head Screwdriver (optional)
The battery life span will be approximately 8 years. After this period, the battery needs to be
replaced. The LumaSMART i Core uses a standard non-rechargeable CR2032 coin-type lithium
battery. The battery holder is accessed from the bottom of the i Core.
Caution: Battery replacement should only be performed by authorized personnel. There is
danger of explosion if the battery is mishandled or incorrectly replaced. Replace the battery
only with one of the same manufacturer and type or equivalent type recommended.
Do not disassemble batteries or attempt to recharge them outside the system. Dispose of
batteries properly in accordance with the manufacturer's instructions and local regulations.
To replace the LumaSMART iCore unit’s battery:
1. Disconnect all electrical connections.
2. On the bottom of the i Core unit, remove the small access panel in the middle using a
medium Phillips head screwdriver. Save the (2) screws.