Installation
33
Due to our policy of continuous product innovation, some specifications may change without notice.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
Floor Standing Wall Support
The Home 8 unit must be installed on the floor with the wall support due to its heavy weight. The
proper environments described in "Installation Location" must be considered. Be sure to follow the
instructions exactly.
Mounting the Home 8
y
It is important to ensure that the drilling locations are not located on any electrical wiring or
plumbing inside the wall.
y
Align both bracket positions correctly. If the bracket positions are not correct, the Home 8
may not be mounted properly.
y
The system must be installed according to NFPA 855.
WARNING
y
Make sure the screws, anchors, and additional supports are appropriate for the wall type.
y
Make sure the pilot hole size matches the anchor type.
y
The weight of the Home 8 is 163kg (359 lbs), and the SE Box is 25 kg (55 lbs). The wall
must contain blocked studs that can bear the weight and are of masonry or other suitable
structures.
CAUTION
y
When attaching the wall bracket to a wall, adjust the horizontal level using an inclinometer
or a leveler.
y
When indicating the position to drill, you can refer to the Mount Hole Guide which is a true
to scale print of the actual wall bracket if required.
y
The Mount Hole Guide is in the SE Box accessory package.
y
Before fixing the bracket screws, check the horizontal level once again using an inclinometer
or a leveler.
y
Depending on the surface, different screws and anchors may be required for installing the
wall bracket. Therefore, these screws and anchors are not contained in the product. The
system installer is responsible for selecting the proper screws and anchors.
y
It is recommended to use stainless steel screws which are 8 mm (5/16 inch) and 76 mm (3
inch) in length.
INFO
