Windows
22
Installing drivers for local printing
L
e
xm
ar
k Co
nf
id
en
ti
al
u
n
ti
l an
no
un
ced - Re
vi
si
on:
02
/18
/05
8
Press
until
<Setting>
appears. Where
<Setting>
=the setting you want to change.
Note the following restrictions:
–
Maximum baud rate supported is 115,200.
–
Data Bits must be set to 7 or 8.
–
Parity must be set to Even, Odd, or None.
–
Stop Bits must be set to 2.
–
Flow Control recommended protocol setting is Xon/Xoff.
9
Press .
10
When you are finished, press
to return the printer to the Ready state.
11
Print a Menu Settings page and verify that the serial parameters are correct. Keep this page
for later use.
a
Press
on the operator panel.
b
Press
until
UTILITIES MENU
.
c
Press .
d
Press
until
Print Menus
,.
e
Press .
f
Look under the Standard Serial (or Serial Option X if you installed a serial interface card)
heading to find the serial parameters.
Installing a printer driver
You must install a printer driver on the computer that is connected to the printer.
1
Insert the drivers CD into your CD-ROM drive. It should launch automatically. If the CD does
not launch automatically, click Start
Æ
Run, and type the following in the Run dialog box:
D:/Setup.exe
Where D=the letter of your CD-ROM drive.
2
Click Install Printer and Software.
3
Click Agree to accept the Printer Software License Agreement.
4
Select Custom, and click Next.
5
Select Select Components, and click Next.
6
Select Local, and click Next.
7
Select your printer from the list, and click Add Printer.
8
Expand the printer item listed below Selected Components.
