Lenovo 653417U, Инструкция по установке и эксплуатации

Страница: 110 / 180

Administrator password
If an administrator password is set, you must type the administrator password for access to the full Setup
utility menu. You can use any combination of up to seven characters (A - Z, a - z, and 0 - 9) for the
password.
If you forget the administrator password, you can reset it after you change the position of the clear
CMOS jumper.
Resetting passwords
If you forget the power-on password or administrator password, you can move the clear-CMOS jumper
block on the system board to pins 2 and 3, to clear CMOS memory and bypass the power-on or
administrator password check. The jumper location is shown in the following illustration.
Microprocessor
Heatsink
Orientation DIMMs DIMMs
Table 14. System board jumpers
Jumper number Jumper name Jumper setting
JP1 Clear CMOS jumper
1
v
Pins 1 and 2: Keep CMOS data
(default).
v
Pins 2 and 3: Clear CMOS data
(including power-on password and
administrator password)
JP6 Boot block jumper
2
v Pins 1 and 2: Boot from primary
BIOS page (default) .
v
Pins 2 and 3: Boot from backup
BIOS page.
Notes:
1.
If no jumper is present, the server responds as if the pins are set to 1 and 2.
2.
Changing the position of the UEFI boot recovery jumper from pins 1 and 2 to pins 2 and 3 before the server is
turned on alters which flash ROM page is loaded. Do not change the jumper pin position after the server is
turned on. This can cause an unpredictable problem.
94
ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Installation and User Guide