OMEGA
Installation Manual
Edition February
2020
Omega
platform lift
page 50 of 52
Configuration of the remote radio controls
2 different systems are offered for the Omega system. The used system has to be defined in
the menu and there 2 different ways to programme the remote radio senders.
Version Schmidiger:
To programme the remotes the button S2 on the platform control board where the receiver
is connected to has to be pressed until the LED on the receiver start to blink.
Now the senders can be programmed. To programme a sender the up and down button on
the sender have to be pressed simultaneously. Then the LED on the sender start to blink in
orange for 2,5 second and then remains on in an orange light and then green light. Now the
sender is programmed. Now the next sender can be programmed in the same way by
pressing the 2 buttons simultaneously.
To stop the programming mode the button S2 has to be pressed again and the action will be
confirmed by the receiver by fast blinking of the LED.
The remote radio controls have different LED status indications. The below status refers to
the radio control model TX-OMDE-V-01:
LED status
Description
Green light
Radio signal ok and drive command is active
Orange light
Radio signal ok and platform is not driving or folding
A reason can be that the platform is driven from the platform control
or that a safety circuit is open in the electrical system.
Red light
Radio signal is ok but the lift is not moved by the command.
Orange blinking
Radio signal is not ok – there is a disruption
Red blinking
The batteries of the sender a weak and should be changed
Green blinking
The sender was successfully connected to the receiver during
programming
Version TeleRadio:
To programme the remotes the button S2 on the platform control board where the receiver
is connected to has to be pressed for 1-6 seconds. After releasing the button S2 the receiver
waits for 5 seconds that any button on the sender to programme is pressed for at least 2
seconds. After he receives the signal from the sender the receiver goes back into normal
operation mode and the sender is saved. Then the next sender can be programmed in the
same way.
