OMEGA
Installation Manual
Edition February
2020
Omega
platform lift
page 30 of 52
In case of such an error the teach-in process cannot be continued. It is necessary to drive
down to the lower landing station and start the whole process again by activating the teach-
in start item in the main menu!
If on the display a failure code can be seen please check in the error code list for what the
problem can be. This failure codes are not related to the teach-in process.
Park position (park position)
CAUTION. Only allowed in countries in which the lift may move independently!
A park position indicates any position on the track. It can be used to automatically send the
lift from a stop position (bottom/middle/top) to any position after a certain time has elapsed.
This can be useful if e.g.the platform in the stop position restricts the passage too much.
Define park position (park position)
The prerequisite is that a learn trip has been completed successfully. At all times, a park
position can be approached only when outgoing from a stop position. To define the starting
position the menu item
"Start park pos.”
has to be selected. However, this can only be done
in one stop position (bottom/middle/top). Then exit the menu and move the platform to the
desired park position (park position). Once there, change to the menu and save the park
position by selecting the menu item
"Stop park pos."
Once the above points have been
carried out, the park position can be used.
INFO: There must be no intermediate stop position between
"Start park pos."
and
"Stop park
pos."
Conditions for entering a park position
The following conditions must be met for the lift to automatically move to the park position.
1. The parameters
"Auto-close"
"Park pos. ON/OFF"
must both be set to ON.
2. Valid learn trip completed
3. The automatic closing/driving is activated only when it is moved into a stop
position with the manual cassette AND a barrier has been fully opened, i.e. the
lift was left with open barriers.
Error code 10 shown
on display
