Landoll Drexel SLT30 AC, Руководство по обслуживанию

Страница: 64 / 82

5-12 F-459-R1
DREXEL SLT30/35 AC CALIBRATION PROGRAMMING
See table below. If the warnings shown below appear,
truck operation “WILL” be disabled. These warnings
(Fault Codes) “WILL” be logged into the truck error log.
IMPORTANT
Immediate attention needs to be given to these
warnings.
C
O
D
E
Display
Message
Possible
Explanation
Possible
Solutions
100 Hi Current Traction External short of phase U, V
or W motor connections.
---------------------------------------
Faulty traction controller. Insure cables are not shorted.
---------------------------------------------------
Replace traction controller.
101 Lo Voltage Traction Battery voltage is too low.
---------------------------------------
Traction contactor precharge
circuit is faulty or missing.
---------------------------------------
Faulty traction contactor.
Charge battery.
-------------------------------------------------------------------------
Replace traction contactor precharge
circuit.
---------------------------------------------------
Replace traction contactor.
102 Hi Voltage Traction Bad connections between
battery and traction controller.
---------------------------------------
Traction contactor open.
Check connections between battery
and traction controller.
---------------------------------------------------
Replace traction contactor.
103 Hi Traction Motor Temp Traction motor temperature is
at or above the programmed
high temperature setpoint.
Bring the traction motor temperature
below the high temperature setpoint
and cycle the key switch.
104 Hi Traction Drive Temp Traction controller
temperature is at or above the
programmed high
temperature setpoint.
---------------------------------------
Excessive load on vehicle.
---------------------------------------
Improper mounting of traction
controller.
Bring the traction controller
temperature below the high
temperature setpoint.
---------------------------------------------------
Reduce load on vehicle.
---------------------------------------------------
Check to see if traction controller is
properly mounted.
105 Traction Comm Fault Traction controller is not
connected to truck harness.
---------------------------------------
Traction controller is not
properly flashed with correct
code.
---------------------------------------
Faulty traction controller.
---------------------------------------
Faulty truck harness.
Check to see if traction controller is
connected to the truck harness.
---------------------------------------------------
Check to see if traction controller is
properly flashed with the correct code.
---------------------------------------------------
Replace traction controller.
---------------------------------------------------
Replace truck harness.
106
Traction Drive Fault Faulty traction controller. Replace traction controller.
107 Traction Contactor Shorted Contacts of traction contactor
shorted together. Replace traction contactor and insure
precharge circuit is properly installed.
https://www.forkliftpdfmanuals.com/