KYMCO XCITING 500, Руководство по обслуживанию

Страница: 8 / 349

1
. GENERAL INFORMATION
1-5
XCITING 500
„
After clamping, check each wire to make
sure it is secure.
„
Do not squeeze wires against the weld or
its clamp.
„
After clamping, check each harness to
make sure that it is not interfering with any
moving or sliding parts.
„
When fixing the wire harnesses, do not
make it contact the parts which will
generate high heat.
„
Route wire harnesses to avoid sharp edges
or corners. Avoid the projected ends of
bolts and screws.
„
Route wire harnesses passing through the
side of bolts and screws. Avoid the
projected ends of bolts and screws.
„
Route harnesses so they are neither
pulled tight nor have excessive slack.
„
Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge or
corner.
„
When rubber protecting cover is used to
protect the wire harnesses, it shall be
installed securely.
„
Do not break the sheath of wire.
„
If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape
or replace it.
„
When installing other parts, do not press or
squeeze the wires.
Do not pull
too tight
！
No Contact
Do not press or
squeeze the
i