KW Aufzugstechnik GmbH Inbetriebnahme DAVID-613
DAVID-D613-Inbetriebnahme-V124-EE 18.02.2022 Seite - 80 -
4.6 Execution of the Remote Trigger Car
In the submenu
C46 Remote Trigger
Car
of the processor system DAVID-613 is possible to activate
the function Remote Trigger Car over the Switch S50 on the operating panel of the controller cabinet in
order to switch on the coil of the speed limiter. After put off the switch S50, the function is switched off.
4.7 Execution of the Reset Remote Trigger Car
In the submenu
C47 Reset Remote Trigger
Car
of the processor system DAVID-613 is possible to
activate the function Reset Remote Trigger Car over the Switch S50 on the operating panel of the con-
troller cabinet in order to switch on the Reset-coil of the speed limiter. After put off the switch S50, the
function is switched off.
4.8 Execution Remote Trigger Counterweight
In the submenu
C48 Remote Trigger Counterweight
of the processor system DVID-613 is possible to
activate the function Remote Trigger Counterweight over the Switch S50 on the operating panel of the
controller cabinet in order to switch on the coil of the speed limiter of the counterweight. After put off the
switch S50, the function is switched off.
4.9 Execution Reset Remote Trigger Counterweight
In the submenu
C49 Reset Remote Trigger
Counterweight
of the proseccor system DAVID-613 is
possible to activate the function Reset Remote Trigger Counterweight over the Switch S50 on the op-
erating panel of the controlercabinet in order to switch on the Reset-coil of the speedlimiter of the coun-
terweight. After put off the switch S50, the function is switched off.
4.10 Execution Endswitch Travel Top
In the submenu
C410 Endswitch Travel
Top
of the processor system DAVID-613 it is possible to over-
drive the highest Levelpoint by switching on the function. The travel ends in the Endswitch Top.
4.11 Execution Endswitch Travel Bottom
The submenu
C411 Endswitch Travel Bottom
of the processor system DAVID-613 it is possible to
over-drive the lowest Levelpoint by switching on the function. The travel ends in the Endswitch Bottom.
4.12 Execution Switchcabinet Temperature Test
In submenu C412 switchcabinet temperature test of the processor system DAID-613. You can decrease
the temperature limit, inorder to produce an error message. It is very important that the switchcabinet
temperature function is active in the menu B600 monitoring functions.
4.13 Execution Motor-PTC Test
In the submenu
C413 motor PTC test
of the processor system DAVID-613 it is possible to simulate a
motor PTC error for one travel, inorder to generate an error in the controllersystem. It is very important
that the PTC-function is active in the menu B600 monitoring functions.
4.14 Execution DSC-Pulse-Encoder Test
In the submenu
C414 DSK encoder test
of the processor system DAVID-613 it is possible to switch off
the encoder of the shaftcopy for one travel. The shaft copying software technically produce an error
response. A condition is natural that in the menu B600 monitoring functions is the DSK monitoring active.
4.15 Execution test Sink-prevention
In the submenu
C415 test Sink Prevention
of the processor system DAVID-613 is possible to activate
the function Test Sink Prevention over the Switch S50 on the operating panel of the controlercabinet in
order to switch off the coil of the speedlimiter. After put off the switch S50, the function is switched off.
