Kval Edge-SS, Руководство по эксплуатации и обслуживанию

Страница: 85 / 180

About the Tool Config Tabs
KVAL Operation/Service Manual
2-50
About Using Tool Configuration
1.
Identify the tool that needs replace-
ment.Measure tool dimensions and
capture the data. (Use this informa-
tion to populate the
Drill or Router
pop-up screens).
2.
Select the
Tool Slot
from the desired
Head (
Hinge Head
or
Lock Head
) .
Note:
Hinge Head 1 and 2 share the
configured tool list. Each head tool should match in type and specifications.
3.
Enter the data into the pop-up screen. (Router or Drill)
Measuring Tool Length
1.
Measure the parameters listed below:
• Total Tool Length - The distance from the collet
face to the tool’s tip
• Tool Cutting Length - The distance from start of
the cutting area to the tip of the bit.
• Tool Point Length- From the point where the
point starts to the end of the bit.
2.
Update the data in the
Tool Setup Group
,
Important: The accuracy of the data Tool Setup Group is
important. Any errors could damage tooling or product.
Tool Point
Length
Cutting
Length
Total Tool
Length