Kval Edge-SS, Руководство по эксплуатации и обслуживанию

Страница: 133 / 180

How to Access to Bit Assemblies
5-24
KVAL Operation/Service Manual
How to Access to Bit Assemblies
1.
Turn off all power to the machine. Follow proper
Lockout/Tagout
procedures as
detailed in the safety section of Chapter 1 of this manual.
Changing a Tool Bit and Using Tool-Change Tightening Fixture
The section describes how to change the bit in a tool, use the Tool-Change Tightening Fixture,
and enter data into the
Tool Setup Group.
.
2.
Measure the parameters listed below:
• Arbor Length - The distance from the collet face
to the tool’s cutting edge.
• Tool Length - The distance from the collet face to
the tip of the bit.
3.
Compare these measurements to the data in the
Tool
Setup Group
in the
Calibrate Machine
Screen. This
screen is accessed by the Setup Button.
4.
Update the data in the
Tool Setup Group
, see “Chap-
ter 2 of the Operation Manual”
Important: The accuracy of the data
Tool Setup
Group
is important. Any errors could damage
tooling or product.
Tool Length
Arbor
Length
Remove and Replace the Router or Pre-Drill Bits
After lockout tagout and access has been obtained to the assemblies, follow these
instructions to remove and replace the router bit or the pre-drill bit.
Remove Old Bit
1.
Use a collet wrench to remove the bit on the pre-drill or router assemblies.See Fig-
ure below.