Kval Edge-SS, Руководство по эксплуатации и обслуживанию

Страница: 161 / 180

Valve Bank Locations
6-18
KVAL Operation/Service Manual
Valve Bank Locations
The Figure 6-29 shows the locations of the valve banks on the machine. The valve banks include
control valves (solenoids) that drive cylinders to move different loads in the machine. The sole-
noid if controlled by the PLC by applying a high voltage or a low voltage to a control coil. Con-
trols for example are: extending and retracting router, drill, clamping a door.
Valve banks are normally located near the load that they drive.
Note: Labels on the solenoids identify loads they control.
Location of Valve Banks on the Edge-SS
Table Valve Bank 2
Table Valve Bank 1
Cutter Head Valve Bank
Deep Drill Valve Bank
FIGURE 6-29.
Location of Valve Banks
The table below lists the typical loads controlled by the valve banks.
Note: The values in this table are typical. To verify, check the labels on the solenoids
and the air schematic.
TABLE 6-2.
Valve Bank Loads (Cylinders)
Extend and Retract: Stops, Feeler, Dust Hoods, Lower Door
Extend and Retract:; Clamps, Lift Table
Extend and Retract: Chisels (X4),Hinge Router, Router, CR Router, Deep Mortise
Extend, Retract., and Lift, Air Inject for Deep Drill
Table Valve Bank 1
Table Valve Bank 2
Cutter Head Valve Bank
Deep Drill Bank